|
Part No:MPDB-I2C-Board-Win-NT |
Win-I2C-NT is a 32-bit
PC-based software/adapter development tool for 100kb/s I²C and a
cost-effective I²C EEprom Programmer.
This package includes
flexible, general purpose I²C software with a user-friendly interface that
runs on any WindowsTM 95, 98, ME, 2000, NT4.x, and XP (now Vista*)
OS.. The software includes support for over 45 dedicated I²C devices,
user-defined I2C/SMBus devices, custom user controls, ascii
file output, and additional features, Hex file support is included for
EEprom programming.
Software updates provided via
our website (instructions included in the Win-I2CNT kit).
The LPT port adapter (I2CPORTv2.0)
was designed specifically for the software; includes 3 different I²C header
configurations, on-board socketed 256byte I²C EEprom
for easy EE programming; and includes jumper selectable 5 or 3.3 volt
capabilities to accommodate I²C buses of either supply
voltage. The adapter can be self powered from the PC parallel port or from
the connected I²C target system. The I²C connections
are standard 4-pin 0.1" stake headers. An LED indicates power and
communication activity.
Note: Win-I2CNT software will also work with a previously purchased Win-I2CNTDLL adapter, and vice-versa,
since the hardware
Supported I2C
Devices
Win-I2CNT Kit Contents:
- Win-I2CNT
software/documentation on CD
- I2CPortv2.0 adapter
(shown above)
- Quick Start Guide
installation sheet
Note: I2C cable is not included
Please note that Win-NT
software is not designed for use with other generic I2C printer port
adapters (such as the "I2CPort" generic adapter).
Only the I2Cportv2.0 adapter series that is
bundled with the software will work properly with the Win-I2CNT software.
(However, our I2Cportv2.0 will work with
other generic I2C parallel port software programs).
|
