Part No: MPPK-CAN-Bus-PCAN-AU5790Bus converter High-speed CAN to Single-wire CAN
The PCAN-AU5790 bus converter establishes a
connection between a high-speed CAN bus (ISO 11898-2) and a single-wire CAN bus (SAE J2411). One of the most important potential applications of the bus converter is a simple connection between a PCAN series CAN interface (e.g. PCAN-USB) and a single-wire CAN bus.
Specifications
- There are three different operating modes for the SW-CAN side which can be set using a sliding switch. Normal (33.3 kbit/s), High-speed
- (83.3 kbit/s) and Wake-up
- Indicator LEDs for power supply (red) and wake-up signals (yellow)
- Power supply (5 V, 150 mA) through HS-CAN connection (a current list of PEAK CAN interfaces with suitable supply voltage is available upon request)
- If the power supply has a lower current output than 150 mA, an additional 12-Volt supply is needed via the SW-CAN connector
- Operating temperature range from 0 to 70 °C (32 to 158 °F)
| Pin assignment Female D-Sub
Connector |
Pin |
Pin assignment high-speed CAN (82C251) |
 |
1 |
5 V Power supply |
| 2 |
CAN-L |
| 3 |
GND |
| 4 |
Not connected |
| 5 |
Not connected |
| 6 |
GND |
| 7 |
CAN-H |
| 8 |
Not connected |
| 9 |
Not connected / optional +5V |
| Pin assignment Male D-Sub Connector |
Pin |
Pin assignment single-wire CAN (AU5790) |
 |
1 |
Not connected |
| 2 |
Not connected |
| 3 |
GND |
| 4 |
Not connected |
| 5 |
CAN |
| 6 |
GND |
| 7 |
Not connected |
| 8 |
Not connected |
| 9 |
VBAT |
Scope of supply
- Adapter in plastic casing
- Manual in PDF format
Downloads
Problems while downloading the files? Use the right mouse button and save as ...
PCAN-AU5790 manual in PDF format (English)
MPPK-CAN-Bus-PCAN-AU5790(002040)
|
