The WI232+ is a single-port WiFi to serial device server that lets you connect serial devices to 802.11b/g/n wireless networks quickly and easily. The WI232+ simplifies connectivity to devices where cabling is prohibited or mobility is required. This next generation of the legacy WI232 adapter provides enhanced software features, a factory reset button, new status LED and a smaller form factor.
Based on the Lantronix xPico™ WiFi® module, advanced security, robust data handling capabilities and high serial speeds are all built in. Using a method called serial tunneling, the WI232+ encapsulates serial data into packets and transports it over 802.11b/g/n wireless networks. By connecting two WI232+ units via a network, virtual serial connections can be extended across your facility or around the world.
WI232+ |
Security/Protection |
256-bit AES Encryption |
Data Rates |
300 bps to 921,600 bps |
Characters |
7 or 8 data bits |
Stop Bits |
1 or 2 |
Serial Interface(s) |
DB9 Female (DCE), DB9 Male (DTE) |
Serial Type(s) |
RS232 |
Baud Rate |
up to 921K |
Control Signals |
DTR, DSR modem controls |
Ports |
DB9 Connector |
Operation Modes |
Simultaneous Soft AP and Client Mode |
Flow
Control |
XON/XOFF, RTS/CTS, None |
Security |
- IEEE 802.11i - PSK with AES-CCMP Encryption
- WPA - PSK
- TKIP Encryption
- 64/128-bit WEP
|
Network Interface |
Interface(s) |
- 802.11 b/g and 802.11n (single stream)
- WLAN Interface (2.4 GHz only)
- IEEE 802.11 d/h/i/j/k/w/r
- WPS2.0 Support
|
Connector(s) |
- Serial: DB9 - DTE (male). Null Modem adapter included (DTE Option)
- Serial: DB9 - DCE (female). Null Modem adapter included (DCE Option)
- Network: Antenna (RP-SMA)
|
Protocols |
ARP, TCP/IP, UDP/IP, ICMP, SNMPv1, DHCP, DNS, and AutoI |
Indicators (LED) |
|
Management |
- Web Server - Landing Page
- Field upgradable firmware (OTA)
|
Internal Web Server |
Storage
Capacity |
|
Architecture |
Firmware |
Upgradeable OTA |
Power |
- .99 W. +5 to +30VDC
- Wall supply Option 9VDC – 500ma
- Terminal Block Option (direct DC power)
- Pin 9 – DB9 connector (from serial device)
|
Temperature Rnage |
- Operating Range: -40°C to +85°C (-40°F to +185°F)
- Humidity Range: 0% to 90% non-condensing
|
Packaging |
Dimensions |
- Housing: 63.5 x 42.67 x 21.7 mm (2.5" x 1.58" x .794") - Case without Cable and Antenna
- Cable Length (including DB9 connector): 460.375mm (18.125 inches)
|
Weight |
62.4 g (2.2 oz) - Approximate, Without Power Supply |
Antenna |
4.3 inch WiFi Antenna Omni-directional ^Rubber Duck^ Antenna, 2.4 GHz, 2.5 dBi, Reverse SMA, 50 Ohm, 20W |